Gateway GM5260, Hardware Reference Manual

Page: 23 / 52

Adding or replacing a CD or DVD drive
www.gateway.com
19
9
Make sure that the positive (+) side of the new battery is facing up, then
press the battery into the socket until it snaps into place.
10
Replace the side panel by following the instructions in “Replacing the side
panel” on page 16 .
11
Reconnect all external cables and the power cord.
12
Turn on your computer.
13
Open the BIOS Setup utility.
14
In the BIOS Setup utility, restore any settings that you wrote down in
Step 3 .
15
Save all your settings and exit the BIOS Setup utility.
Adding or replacing a CD or DVD drive
Tips & Tricks
You need a Phillips screwdriver to add or
replace a CD or DVD drive.
To add replace a CD or DVD drive:
1
Remove the side panel by following the instructions in “Removing the side
panel” on page 14 .
2
Remove the front bezel by following the instructions in “Removing the
front bezel” on page 15 .
Important
The color and shape of your replacement
drive’s front cover may vary from your
original drive.
3
If you are installing a new drive (not replacing an old one), remove the two
drive retention screws in the drive bay, then go to
Step 7 . For the location
of the screws, see the photo in Step 6 .
4
If you are replacing an existing drive, disconnect the cables from the drive,
noting their locations and orientation. You will reconnect the cables after
you install the new drive. (CD/DVD drive shown.)
5
Note any jumper settings on the old drive and set the jumper on the new
drive to be the same.