Gateway E1400, System Manual

Page: 67 / 136

60
System Components
3
Push the tray assembly toward the chassis until the three tabs at the top
of the tray assembly are seated in the corresponding slots on the chassis.
4
Push the handle in and slide the tray assembly downward until it locks
the tray in place.
5
Turn the chassis around and press down on the top edge of the system
board to make sure that it is firmly seated in the riser card slot.
6
Replace or reconnect the following devices:
Processor. (See “Replacing the processor” on page 61.)
AGP graphics card. (See “Replacing the AGP card” on page 51.)
Peripheral devices attached to the rear-panel I/O connectors.
Devices from the old system board that are not included with the
new board. (See “System board” on page 7 for device locations.)
7
Replace the left and right panels. (See “Replacing the side panels” on
page 23 for instructions.)
8
Reconnect the power cord and all other cords you removed, then turn
on the system.
Tabs
Tab slots
05960.book Page 60 Monday, February 21, 2000 2:47 PM