Gateway ADAC Ultra2 S466, Hardware Manual

Page: 69 / 112

Chapter 6 Hardware Installation 55
Step 1 Unpack
Unpack and install the hardware in a static-free
environment. The ADAC Ultra2 S466 controller card is
packed inside an anti-static bag between two sponge
sheets. Remove the controller card and inspect it for
damage. If the card appears damaged, or if any item listed
below is missing, contact your OEM support
representative. The ADAC Ultra2 S466 Controller is also
shipped with:
•
the ADAC Ultra2 S466 Configuration Software Guide,
•
the ADAC Ultra2 S466 Operating System Drivers
Guide,
•
the ADAC Ultra2 S466 Hardware Guide,
•
the so
ftware license agreement,
•
the ADAC Ultra2 S466 Configuration Utilities
diskette for DOS, and
•
the warranty registration card.
Step 2 Power Down
Turn off the computer and remove the cover. Make sure
the computer is turned off and disconnected from any
networks before installing the controller card.
Step 3 Configure Motherboard
Make sure the motherboard is configured correctly for
ADAC Ultra2 S466. ADAC Ultra2 S466 is essentially a
SCSI Controller. Each ADAC Ultra2 S466 card you install
will require an available PCI IRQ; make sure an IRQ is
available for each controller you install.