The XA10 / HF-G10 Setup
Page 9
Installing the Camera into the Housing
Carefully slide camera on its CM
into the front housing half. The CM will mate and
slide into the mating mount on the housing.
Observe
that the camera mates into the alignment collar at the front of the shell,
just behind the port opening.
Secure the camera
by rotating the lock clockwise until snug.
Open the LCD fully
as shown below.
Press in controls.
When the camera is installed into the front housing half, press
in the Focus and Assignable controls to mate with the camera.
Check controls.
At this point it’s a good idea to check all controls on the front shell
for proper operation. (See section 4 for controls mentioned here.)
Slide camera into housing until fully forward.
Open the LCD fully and make sure
Remote is pushed in all the way.
Secure by rotating the lock clockwise.
Carefully push in the Assignable
Control into position over the buttons
as shown.
