The XA10 / HF-G10 Setup
Page 7
3:
The XA10 / HF-G10 Setup
The XA10 / HF-G10 housing requires complete and thorough setup prior to use.
XA10 / HF-G10 Housing Preparation
Open the XA10 / HF-G10 shell.
Two stainless steel safety latches secure the
housing halves. They have a positive locking feature, so to open them you must
first depress the center bar release while lifting the rear lever.
Separate
the rear half of housing from the front.
Remove the Camera Mount (CM).
Rotate the lock counterclockwise and slide the
mount to the rear.
Retract and Rotate controls.
Pull out the Focus, Assignable, Custom Button /
Dial, Zoom and Power control about one inch or until they stop.
Rotate the lock to this position and
slide the CDM out of the housing.
Release the latches and separate
the housing shell halves.
