9/5/2007
10
D. To remove the dies, place a hand under the desired shoe to remove. Pull the
corresponding die shoe locking pin out with the Die Removal Tool and catch the die
finger. Set the die finger aside.
E. Repeat step D. on the remaining die fingers.
Note- There is not a die storage system available for the GC96 large
bore dies.
Fig. 2 Installing the GC32 dies in the GC96 crimper
Installing the GC32 standard Die Sets and using the Quick Change
Tool
Refer to Fig. 2.
A. Refer to Fig. 3. To load the GC32 die
sets with the Gates GC32 Quick Change
Tool (QCT),
•
Press the OPTIONS SCREENS tab,
•
Press the TOOLS tab.
•
Press the DIE CNG button
•
B. This will position the shoes to accept the
QCT. Depending on the position of the
head, the head may fully open. If this
happens, press the DIE CNG button again
and the shoes will position to allow
changing the dies out with the QCT.
GC96
Spacer
dies
Die
Removal
Tool
GC32
Quick
Change
Tool
GC32 Die
Set
Summary of Contents for GC96
Page 22: ...9 5 2007 21 SCHEMATIC...
