![background image](http://html1.mh-extra.com/html/gates/ax100/ax100_setup-use-and-care-manual_3744861012.webp)
The AX100 Setup
Page 12
Closing the Housing
Carefully inspect
o-ring on back half and the sealing surface on front half. Make
sure they are clean and in good condition.
Turn ND Filter control
all the way down to the OFF position. This will help align the
housing control to the camera when the back half of the housing is installed.
Place back half onto the front housing half.
You will clearly see when the
housing halves align and seat together properly.
Locate and close
the two latches at the same time.
CAUTION
:
The safety latches must be closed and locked prior to use to avoid
opening underwater. It is your responsibility to make sure the latches are secure,
locked, and in good condition. DO NOT enter the water with a faulty latch. Gates
will replace a damaged or faulty latch free of charge.
Inspect the o-ring on the rear shell
and the sealing surface on the
front shell. They should be clean
and free of nicks, marks or
scratches.
Rotate ND Filter control to
the down / off position
before installing back half
of housing.