The AX100 Setup
Page 13
Carefully inspect the parting line
between front and rear housing. If this line is
not even all the way around, remove the back and determine the reason. (O-ring
out of place, hand strap interference, etc.) Failure To Do This May Result In A Wet
Camera!
Power up the camera.
Check all controls for the proper operation before entering
water. If ND Filter Control is not seated properly on the camera it can be pulled out,
aligned over the camera control and pressed back in. (See section 4)
Install a port.
Visually align the bayonet mount on the port with the housing. Mate
the port to the housing, and press. It should seat fully with no gaps around the
base.
Rotate the port
90° either direction to fully engage the port. For specific
details, see the section Changing Ports on page 25.
Install back housing half
Inspect the parting
line.
