Gates Underwater Products, Inc
13685 Stowe Drive • Poway, CA • 92064 • 858.391.0052 • 800.875.1052 • 858.391.0053
[email protected] • www.GatesHousings.com
4
01/13/10
Preparing the Housing
9
Release the latches.
Release the three stainless steel safety latches that secure
the housing halves. Release the side latches first, followed by the top latch. They
have a
positive locking
feature, so to open them you must first depress the center
bar release while lifting the rear lever. Depress the bar and lift the rear lever on both
latches at the same time.
9
Open the housing.
Separate the rear half of housing from the front.
9
Remove the camera tray from the housing.
The tray is released by rotating the
locking latches 90 degrees in opposite directions. Refer to the photo. Once
released the tray will easily slide out of the housing.
9
Pull out controls
on the left side of the front shell as far as they will go. Note that
controls will be addressed in greater detail in a subsequent section.
9
Rotate the Rec/Stdby control
90 degrees clockwise so the arm is horizontal toward
the rear of the housing.
9
Pull out video and audio connectors
(if applicable) and wrap to the side or top of
the housing out of the way for camera insertion.
Release the latches. Start
with the side latches, then
the top.
To remove the camera
tray rotate the latches
90 degrees.
