Intelligent Temperature Sensing Systems (ITSS)
User Manual & Install Guide
4 of 28
SAFETY AND INFORMATION SYMBOLS USED IN THIS MANUAL
This symbol draws the user’s attention to
recommended best practices
which should be observed when installing and using the product.
The battery must be disconnected from the vehicle before
working on the electrical system of the vehicle when installing,
servicing or removing Gatekeeper products.
Preparing to Install
▪
Customers shall be responsible for addressing any systems on the bus that require
attention as a result of disconnecting the bus battery. This includes, but is not limited
to, entering a radio theft code, programming radio stations, etc.
Installing the product
▪
All Gatekeeper Systems employees or contractors who perform electrical work (e.g.
installing, servicing or removing an Intelligent Temperature Sensing Systems, installing
a backup camera system, etc.) on a customer vehicle shall ensure that the battery in the
vehicle is disconnected before work commences.
Operating the product
▪
The ITSS has an operating temperature range of 32°F to 122°F (0°C - 50°C). It is good
practice to ensure that the product is mounted in a suitable location that does not
exceed acceptable temperature ranges during normal operations.
▪
Do not remove the cover of the product as this will void the warranty.
Updating the product
▪
Firmware updates (available from
) are system and
product model specific. These firmware updates must be applied to the ITSS system
only.
Repairing the product
▪
Your ITSS
doesn’t have any user
-serviceable parts. Do not open or disassemble it or
attempt to repair it or replace any components.
▪
Disassembling the ITSS may damage it or may cause injury to you. If your product needs
service, is damaged, or malfunctions, contact Gatekeeper Systems for assistance. If you
attempt to open it, you risk damaging your product
, and such damage isn’t covered by
the warranty on your ITSS.
If at any time there is a question about how to proceed, please contact Gatekeeper Systems immediately
at either 1-888-666-4833 or 1-604-864-6187 for assistance. Review all available installation
documentation, including technical bulletins. Additional resources, technical bulletins and product
tutorials can be found at
