92
25. Put heat-shrink tube on a wire, cover the connector with a thin layer of
solder (always use flux or rosin during soldering, especially when solder
melts. This is necessary to achieve the correct connection).
26.
Have a look at the connection and check if it is done properly. Pay
attention to solder – it should fill soldered space correctly and solder
should not be oxidized. Remove excess rosin from the connection.
Summary of Contents for Titan
