Gastros InductWarm 140, Original Instructions Manual

Page: 35 / 56

35
•
Avoid direct contact of the device with food.
•
Only use dishes that have been designed as suitable for induction by the manufacturer. Only use dishes
suitable for inductive heating with a minimum bottom diameter of 12 cm/ 4.7“. It is possible to use smaller
dishes, but this may have the following effects:
o Reduced efficiency
o
Potential absence of dish detection
o
Greater radiation
•
Never keep dishes warm without moist food. This poses a risk of the dish overheating.
• Switch off the InductWarm
®
140 unit if you remove the dishes and do not intend to immediately continue
using the device. This will prevent unintentional heating in the event that you or someone else places
dishes on the surface above the induction unit.
•
Do not heat up tins or other sealed containers, as this can cause an explosion! Items that are unsuitable for
use include any dishes that are not specifically intended for induction appliances, as well as metal splash
guards, aluminium foil, cutlery, jewellery, watches, metallic objects, etc.
•
The induction device is considered to be switched on when the ON/OFF button on the control panel lights
up green.
Error Possible cause Elimination of error
No heat, ON/OFF button
does not light up in any color
No power supply
Plug the device in,
check the plug connection
Power supply fuse tripped Check and reset the fuse
Device is not switched on
Check the plug connection, turn on
the power switch on the bottom of
the device
Device is defect
Contact customer service
servicepoint@gastros.swiss
No heat, power level button
1, 2, 3 or 4 is flashing blue
Dish is not detected
Dish is too small, incorrectly placed
or not suitable for induction
Infrared remote control is
not working
Low battery Replace the battery
The transmitter or/and receiver are
dirty
Clean transmitter and receiver
No electrical contact between battery
and remote control Ensure contact between battery and
remote control
Dish does not get warm
enough
Incorrect placement of dish
Ensure right position above the
induction coil
Insufficient energy supply Increase power level
Dish is not suitable for induction
Check induction suitability, use
induction-compatible dish
ON/OFF button flashes
alternately red and yellow
Technical error detected in the device
Contact customer service
servicepoint@gastros.swiss