GTD-2000TxW
Instruction Manual
5. Installation
5.2. Main PCB Configuration
■ After detaching the display parts, the Main PCB terminal layout appears as shown in the figure below.
[Table 2. Main PCB Key Part Description]
No
NAME
DESCRIPTION
1
CN9
Power & Output Signal Terminal
2
J1
4~20mA Source / Sink Selection Jumper ( ON: Source Type, OFF: Sink Type)
3
CN1
Display LCD Connector
4
CN8
Sensor Connector
5
CN6
Program download Connector
6
D1
Status LED (Flashes in 1 sec interval during normal operation)
7
OC1,OC2,OC3
HART Option Board Connector
8
CN4
Warning light (GTL-100) Interface Connector
[Figure 5. Main PCB Terminal Layout]
■ Using OC1, OC2, and OC3 shown in the layout above, HART option board can be attached and 3ØScrew holes
located at top left of HART option board are used for fixing.
