- It is password change menu.
- The password is for entering device setting menu and pressing UP (▲) or DOWN (▼) key
-
increases or decreases number for password.
- Password can be set in a range between '00~99 and default is '00'.
- After setting the password, press FUNC key to save the setting and move to the next menu.
- It is a function to automatically change measuring channel. When it is set to On, it changes
-
from channel 1-1 to 16-8 in an order each sec and displays the measurement in measuring
-
mode.
- Default setting is 'OFF'. Press FUNC key to save the setting and move to the next menu.
- It displays end of configuration menu. Pressing FUNC key changes to the initial menu page
-
"[F1]/CONF".
www.gastron.com
18
_
19
GTC-700
Instruction Manual
■ When "FUNC" key is pressed for 2 sec or longer in measuring mode, it enters password input step.
6.3.1. Configuration Mode
- After entering password using UP (▲) or DOWN (▼) key followed by pressing FUNC (Function)
-
key, it enters Function Mode. (Default = "00")
- It displays "FAIL" message in an event of password error.
- Using UP (▲) or DOWN (▼) key, select “[F1]/CONF” (Configuration menu) then press FUNC
-
key to enter sub-menu setting.
- It is a menu that sets Modbus Slave Address.
- For address input, pressing UP (▲) or DOWN (▼) key increases or decreases number.
-
Setting range is OFF~32 and default is OFF.
- After setting the address, press FUNC key to save the setting and move to the next menu.
6. Operation Method
6. Operation Method
