-
use the machine in altered psychophysical conditions; under the
influence of drugs, alcohol, psychotropic drugs, etc..
-
install the machine on top of other equipment.
-
use the machine in explosive, aggressive or high concentration of dusts
or oily substances suspended in the air;
-
the use of the machine in an atmosphere where there is a risk of fire;
-
the use of the machine to dispense substances unsuitable for the
characteristics of the machine;
-
cleaning or maintenance of the machine with the main switch on the
position -ON- and with the plug inserted in the socket.
-
Before cleaning the machine, make sure the plug is unplugged from the
outlet; wait until the machine has cooled down properly.
-
Do not wash the machine with petrol and/or solvents of any kind.
-
Any repair can only be carried out by an Authorised Service Centre
authorised by the Manufacturer and/or in any case by specialised and
trained personnel.
-
Do not place the machine near heating systems (such as stoves or
radiators).
-
In case of fire, use carbon dioxide (CO2) extinguishers. Do not use water
or powder extinguishers.
-
In case of improper use, any form of warranty will be forfeited and the
manufacturer will not be liable for any damages.
-
declines any responsibility for damage to persons and/or property.
Stop functions
The machine stop functions are delegated to the main switch.
Included accessories
- Brush: to perform the correct cleaning of the chocolate dispensing
channel.
Assembly
The following must be verified:
- that the room has been prepared for the installation of the machine;
- the room is sufficiently lit, ventilated, hygienic and the power socket is
easily accessible;
- the floor on which the machine is installed is flat, solid and stationary;
- the machine is placed at least 20 cm (7.8 inches) from the edges of the
table used.
The access spaces to the machine must be left free to allow the operator
to intervene without any constraint and also to be able to leave the
working area immediately if necessary.
After positioning the packaging near the installation area, proceed as
follows:
- open the upper part of the packaging;
- lift and remove the machine from the packaging;
- then place the machine in the space provided.
Before putting the machine into operation for the first time, you must It
is necessary to carefully clean the component parts.
Electrical connection
This operation must be carried out by technical personnel only.
specialized.
Before inserting the plug into the socket make sure that:
- the voltage of the power line used corresponds to the value indicated
on the manufacturer's rating plate;
- the main switch is set to -OFF-.
