41
CARE AND CLEANING
WARNING:
Never hold your face or other body parts over the feed funnel
when the motor is running because little pieces of food could be thrown out of the
feed funnel. Never put foreign substance or hard objects into the feed funnel.
Before the mincer is used for the first time, all parts – with the exception of the motor
block – must be thoroughly cleaned in warm soapy water.
DISASSEMBLING
WARNING:
To avoid injury and damages of the appliance turn the appli-
ance off and then wait for approx. 6 seconds to be certain that the motor is no
longer running. Always pull the plug before you start disassembling or cleaning the
appliance.
1. Switch off the mincer and disconnect the power cord from the mains. Check that
the motor has completely stopped.
2. Detach the worm housing from the motor block.
3.
Unscrew the closing ring turning it counter clockwise.
Tip:
If the closing ring is screwed on to tight you can
use a screwdriver as shown in the picture 10.
4. Remove the grinding disc. If necessary insert a knife or screwdriver between the
grinding disc and the worm housing to pry out the grinding disc.
5. Remove the crossed-blade knife and pull out the worm or if you used the chopper
attachment remove them.
Tip:
If the tools are stuck, knock the mincer carefully on a stable cutting board. The
grinding disc should be facing up.
ATTENTION:
Be careful not to damage your bench top, the cutting board or
the mincer.
6. Remove meat residues.
Operate as described:
ATTENTION:
Never put the appliance or parts of the appliance in the dish-
washer or use abrasives for cleaning!
Summary of Contents for Fleischwolf Pro
Page 24: ......
