39
Note:
The kettle is no measuring appliance. There may be differences between the tem-
perature displayed on the display and the actual temperature of the water. Addi-
tionally, after heating the actual water temperature may be somewhat higher than
the set temperature. Take this into consideration, especially when setting low tem-
peratures and heating small amounts of water.
6. Set the desired temperature by pressing the temperature selection button shortly
several times until the desired temperature will flash on the display. You can set
the desired temperature from 50°C to 100°C (boiling) in steps of 5°C.
Note:
If you wish to heat up to the same set temperature as last time, you can start the
heating cycle without any settings. The appliance will always keep the recently
used temperature in memory. Additionally, you may use the shortcuts for setting the
temperature: 100°C (hold the KEEP WARM button pressed for 2 seconds), 80°C
(hold the temperature selection button and KEEP WARM button pressed simultane-
ously for 2 seconds), or 60°C (hold the temperature selection button pressed for 2
seconds). See also: ‘Properties of Your Water Kettle’
7. Simply press the ON/OFF button to start the heating cycle. The kettle will start
heating immediately. On the display, the actual water temperature will be
shown.
8. If you wish to use the keep warm function, shortly press the KEEP WARM button.
You may activate or de-activate the keep warm function during operation just as
you like.
9. As soon as the water reaches the set temperature, the kettle will switch to the next
step automatically. With the keep warm function activated, the ON/OFF button
will change to yellow and the kettle will keep the water at the set temperature for
30 minutes. Thereafter, the appliance will switch off the heating elements and
return to standby mode with a beep. The ON/OFF button gets dark.
Note:
You may cancel the operating cycle at any time by removing the kettle from the
power base, or by pressing the ON/OFF button. Do not leave the keep warm
function run uselessly to avoid excessive energy consumption.
After being idle for approx. 30 minutes (ON/OFF button is dark), the kettle will shut
off completely and the display gets dark. Simply press any button to switch on the
display again.
Summary of Contents for DESIGN KETTLE MINI
Page 47: ...47...
