Empty the Pulp Container During Juicing
The pulp container can be emptied during juicing by turning the appliance ‘Off’ at the control
panel and then carefully removing the pulp container. Remove the pulp container by tilting the
pulp container slightly to the right and unlatch it from under the juicer cover and the container
support extending from under the motor base. Replace the empty pulp container into position
before continuing to juice.
overload Protection Button
The Design Juicer Advanced Pro is fitted with a safety device which safe-
guards against overheating with excessive loads. If this occurs, the juicer
will automatically activate the overload protection button and the unit will
switch itself off. If this occurs turn the power OFF at the power outlet and
allow the unit to cool. Then press the overload protection button found on
the bottom of the motor base. The safety device will then be reset and the
juicer is ready for use again.
IMPorTANT:
Put aside the juice jug and the pulp container before you turn the motor base
around carefully to activat the overload protection button. The juicer is ready for use and you
can continue juicing after putting the pulp container and the juice jug back into position. In
case overload protection button gets activated straight away again refer to the trouble shoot-
ing guide.
Disassembling our Design Juicer Advanced Pro
WARnInG:
Always turn the appliance off and pull the plug
when the appliance is not in use or when disassembling, mov-
ing or cleaning the appliance.
Step 1:
Ensure the appliance is turned off by pressing the Off’-switch
on the control panel and unplug the cord.
Step 2:
Remove the pulp container by tilting the pulp container slightly
to the right and unlatch it from under the juicer cover and the
container support extending from under the motor base (picture
A).
Step 3:
Use the grip handle located on the safety locking arm to lift
the locking arm from the juicer cover and lower down out of
position (picture B).
Step 4:
Lift the juicer cover off the juicer (picture C).
Step 5:
Remove the filter bowl surround with the stainless steel filter
basket still in place. To remove the filter bowl hold the base of
the juicer and turn the filter bowl surround by the juice spout
clockwise (picture D).
42
A
C
B
Summary of Contents for Design Juicer Advanced Pro
Page 23: ...23 Rezept Ideen ...
