Safeguards for Daily operation
• Only use the appliance for the intended purpose. Any non-appropriate use and misusage
can cause damages and heavy personal injuries through voltage, fire and moving units. Only
proceed the appliance as described in the directions.
•
Do not
use the appliance in moving vehicles or boats. Only use the appliance indoors.
• Store and use the appliance in a clean, frost free environment where it is protected from
dampness, moist and immoderate and extraordinary burden (such as: downfall, beat, over-
heating, moisture in the motor base) .
•
Do not
use or store the appliance outdoors.
• Store appliance and units out of reach of children.
• The work space has to be easily accessible, solid, even, dry and of sufficient size.
Do not
use the appliance in moist and wet areas.
• Operate the appliance on a well accessible, stable, level, dry, and suitable large surface.
Do not
place the appliance or any part of it on or near hot surfaces (heater, gas burner, grill,
or oven).
Do not
place the appliance near the edge of the table or counter or on inclined or
wet surfaces or where it can fall.
• Reparation and technical maintenance of the appliance or line cord are just allowed to be
accomplished by an authorised specialist reparation shop.
•
Do not
use the appliance if it is damaged or units of the appliance are damaged.
Do
not
use the appliance if it does not function properly or if it was excessively loaded. The
appliance is likely damaged if the appliance or units of the appliance show cracks, exorbitant
wearing down, alterations or leaks. It is also likely damaged if the drive wheel of the motor
base moves slowly. Do not use the appliance if the rotating sieve is damaged. Take the appli-
ance for technical maintenance and repair to an authorised specialised reparation shop.
• Only use units, spare parts and supplies which are provided and recommended by the manu
-
facturer. Damaged or improper units may break in use, damage the appliance or cause injury.
•
Do not
push products into the feed chute with your fingers or foreign objects. Always use
the food pusher provided.
•
Do not
touch the small cutting blades in the base of the stainless steel filter basket.
• Always make sure the appliance is properly and completely assembled before connecting
to power outlet and operating. The unit will not turn ‘ON’ unless properly assembled.
•
Do not
let the motor run permanently for longer then 7 minutes to avoid overheating.
•
Do not
operate the appliance continuously on heavy loads for more than 1 minute. The
Design Juicer Advanced Pro is fitted with a safety device which safeguards against overheat-
ing with excessive loads. If this occurs, the Juicer will automatically activate the overload
protection button and the unit will switch itself off. If this occurs turn the power off at the
power outlet and allow the unit to cool. Then press the overload protection button found on
the bottom of the motor base. The safety device will then be reset and the Juicer is ready for
use again.
• While proceeding
do not
push the food pusher too hard down. Empty the pulp container
and juice jug in time to avoid run-over and splatter which might causes damages to the appli-
ance. When proceeding hard or stringily food or if you press the stamp down too hard the
motor could stop or slow down. In this case turn off the appliance immediately and pull the
plug to avoid overheating. Operate according to the instructions ›Trouble shooting guide‹.
36
Summary of Contents for Design Juicer Advanced Pro
Page 23: ...23 Rezept Ideen ...
