![background image](http://html1.mh-extra.com/html/gastroback/design-handmixer-pro/design-handmixer-pro_operating-instructions-manual_3717963065.webp)
65
9. Press the “Pulse” button to start the motor. The motor will agitate only with the
“Pulse” button pressed and stop as soon as the “Pulse” button is released.
10. Without tilting the bar blender, you may
slowly and carefully
move the bar
blender up and down a little within the blender container.
11. As soon as your food reached the desired consistency, release the “Pulse” button
and wait until the motor stops completely.
12. Immerse the bar blender into the provided warm dishwater. Ensure to make
the bar blender touch the bottom of the container. Then hold the “Pulse” button
pressed for some seconds to remove residues of food from the blades of the bar
blender. Release the “Pulse” button, slide the speed selector to position “0”, and
unplug the appliance.
13. Remove the bar blender immediately after use (see below).
Removing the Bar Blender
WARNING:
Always set the speed selector to “0” (off) and unplug the motor unit,
before removing the bar blender. Do not attempt to release the bar blender during
operation. Do not grasp into the bell-shaped end of the bar blender when handling
the bar blender to avoid injuries. Always grasp the bar blender by the shaft.
14. Ensure that the speed selector is switched to position “0” (off), and the motor unit
is unplugged.
15. Grasp the bar blender by the shaft and turn the bar blender counter-clockwise
to the stop. Then pull the bar blender out of the drive compartment. The shutter
will close automatically.
16. Clean all used accessories immediately after use (see: ‘Care and Cleaning’).
USING THE CHOPPER SYSTEM
WARNING:
The blades of the chopper knife are very sharp. Do not touch the
blades to avoid injuries. Only touch the chopper knife at the upper part of the
shaft. For your safety, the chopper knife cannot be driven by the motor unit direct-
ly, but only via the chopper lid. Additionally, the chopper knife will fall off the
chopper lid, if the chopper lid is lifted from the chopper container. Thus, it is almost
impossible to operate the chopper system with any of the accompanying parts
missing. Do not attempt to corrupt this safety feature via using any type of foreign
containers. Do not attempt to operate the chopper system with any of its parts
damaged in any way. Before switching on the motor unit, always ensure that the
chopper system is installed completely and correctly.