The mincer blocks up permanently
while operating.
The worm housing moves or loosened while
operating.
The mince leaks out at the side of the
closing ring.
Clear a blocking
If the worm housing is blocked no mince comes out of the mincer while operating or the motor stops
moving automatically because of the overload protection.
ATTENTION:
If a blocking occurs turn OFF the appliance immediately. Clear the problem
before turning on the motor again.
1. Turn the appliance OFF and then take the feedstick out of the feed funnel.
2. If the motor stopped running because the overload protection turned itself on you have to
turn the appliance OFF to undo the overload protection.
3. Press the reverse button and hold it down for one or two seconds. The worm is moving
backwards and this loosens the blocking.
ATTENTION:
If the motor does not start moving backwards immediately turn OFF the
appliance and pull the plug. Disassemble and clean the appliance.
• To ensure that the mincer does not seize, never operate it under
excessive pressure. Operate in a slow and constant pace. Do not
try to rush the procedure by pushing down the meat with force.
• For mincing hard ingredients really fine start with the mincer plate
with the bigger holes. Mincing the second time use the finer mincer
plate.
The screw plug loosened. Turn the appliance OFF immediately. Press the
worm housing with one hand against the motor housing using the other
hand to tighten the screw plug turning it clockwise.
The closing ring is not screwed on tight enough. Turn the appliance OFF
immediately and then pull the plug. Tighten the closing ring but do not
overwind the winding. If the problem still occurs disassemble and clean
the appliance.
Possible problem
Easy solution
30
41400_Manual_Fleischwolf_Juni2008.qxp 11.06.2008 11:04 Seite 30