•
Never
try to take the appliance to pieces or open it.
•
Never
leave children unsupervised when the appliance or units of the appliance are in reach.
•
Never
let children play with the appliance or units of the appliance. Children and invalid
people have to be supervised using the appliance.
•
Never
leave the mincer unattended, when connected to the power supply. Keep the appli-
ance well out of reach of children. Store the appliance and units out of reach of children.
•
The work space has to be easily accessible, solid, even, dry and of sufficient size. The
mincer should only be set up on a firm level work surface.
Never
situate the appliance close
to the edge of the working area. Ensure that the power supply cable does not hang down from
the work surface as it could be easily pulled, particularly by small children, thereby causing seri-
ous accidents.
•
Never
cover the air box on the back of the appliance. The air has to able to circulate.
•
Never
immerse the motor block in water! Short-circuit danger! Do
not
put any cloth or
napkins underneath the appliance to avoid endangering by fire and electric shocks.
•
Never
situate the appliance close to a strong heat source or a hot surface (for example:
heater, stove or grill).
•
Ensure that the switch and cable do not come into contact with water! Should this
inadvertently happen, all parts must be completely dry before the appliance is used again.
•
Never
let water or other liquids run into the motor housing.
•
Never
clean the line cord or the appliance in the dishwasher, poor liquids over the
appliance or douse or dip it in water or other liquids. In case that water or other liquids ran
into the appliance while operating turn OFF the appliance immediately, pull the plug and dry
the appliance with a clean cloth (´Care and cleaning`).
•
Do
not
use the appliance in moist and wet areas.
•
Check the power supply cable regularly for wear and damage.
•
The mincer must only be connected to a 230 V power supply.
•
Always disconnect the power supply cable from the mains before assembling, dismantling
and cleaning the appliance or before exchanging mincing plates.
• Always uncoil the line cord completely before installing the appliance.
• Place the appliance close to a power point and connect it directly without using any extension
cords to avoid additional risks of injury through fire or voltage.
21
41400_Manual_Fleischwolf_Juni2008.qxp 11.06.2008 11:04 Seite 21