Thank you for purchasing our reversible heat pump water heater for your Swimming Pool/Pond. Our heat
pump was produced in accordance with the current European Standard and it is now ready to be used.
Please read this manual carefully before install the heat pump, otherwise it may lead to damage to the heat
pump or may injure operators as well as cause financial loss.
The heat pump should be installed by professionals or qualified technicians.
Heat Pump Technology
Heat pumps utilize the sun's free heat by collecting and absorbing energy from the outside air. This energy
is then compressed and transferred to the pool/pond water. Your existing water pump circulates the water
through the heater, usually next to the pool equipment, and the water warms up.
The unit contains a fan that draws in outside air and directs it over the surface of the EVAPORATOR
(energy collector).The liquid refrigerant within the EVAPORATOR coil absorbs the heat from the outside air
becomes a gas.
The warm gas in the coil passes through the COMPRESSOR concentrating and increasing the heat to form
a very hot gas which then passes to the CONDENSER (water heat exchanger).It is here that the heat
exchange occurs as the hot gas gives off heat to the cool swimming pool water circulating through the coil.
The pool water becomes warmer, and the hot gas cooling as it flows through the CONDENSER coil returns
to its liquid form and, after passing on through the CAPILLARY TUBE the whole process begins again.
The state of the heat pump technology can efficiently collect heat from the outside air down to the 7°C to
10°C range. For tropic and subtropical climates, this means that the pool
can be maintained at 26°C to 32°C.
2
Warm
Air
Fan
Evaporator
(Energy Collector)
Capillary Tube
Pool Filter
Condenser
(Water Heat Exchanger)
Pump
Cooler
De-energized Air
Compressor
Swimming pool
Heat exchanger Water flow out
Evaporator
Air flow
Air flow
Compressor
Water flow in
1.
Introduction of Pool Heat Pump
