Gaspardo GENIUS, Use And Assembly Instructions / Spare Parts, Page: 24 / 37

USE AND MAINTENANCE
ENGLISH
g
cod. G19502880
50
4.5.1 CAL CHECK
The product cal factor can be checked and corrected, if needed, by trying to distribute a user-defined quantity of product.
The check consists in the following steps.
1) Position the required containers under the metering units and open the spouts for
product discharge (Fig. 48).
2) Turn the switch in the main electrical box to ON (W in Fig. 49).
3) Switch on the panel and wait until the initialization process is completed (approx. 8 to 10
seconds).
4) Press the button SETUP followed by “Drill Setup” first and “Cal Check” .
then.
5) Use the numeric keypad to enter the quantity of product to be distributed for the check
(Fig. 55).
6) Start the check by pressing the ENTER button in the panel. Collect the distributed
quantity of product in a container.
7) The motor stops automatically when the set quantity is reached. Weigh the collected
product and use the keypad to enter the net value of the product weight.
8) Press ENTER twice to confirm the parameter value. The display shows the test
results (Fig. 56):
- previous cal factor;
- new cal factor;
- correction percentage;
- new max. speed calculated.
9) Press ENTER to confirm or ESC to cancel the operation.
10) The display goes back to the SETUP menu. Press MAIN to go back to the main page.
WARNING: after the test, close the spouts (Fig. 48).
fig. 55
fig. 56
PARAMETER TABLE
Table 6 can be used to write down the results of the cal tests according to the type of product used for the test (seeds or fertilizer)
and its specific weight.
PRODUCT FEATURES TEST RESULTS
No. PRODUCT type Specific weight Cal Factor T.W.G.
( seed/fertilizer) (Kg/dm³) (Kg/turn) (gr/1000 grains)
1
2
3
4
5
6
7
8
9
10
Table 8