3
2
Specific Safety Instructions
WARNINGS
Do not use the heater in areas where
there is a risk of explosion or fire from
flammable gases. Ensure that the heating area
is kept clear of combustible materials. Do not
use the heater in damp areas, without suitable
ventilation. This heater is not designed for use
within 1m or above a water source. Do not place
within one metre (1m) of any water source. Do
not place directly in front of, below or above any
power points or switches.
Fire risk exists if this heater is covered by
or positioned close to curtains or other
combustible materials.
• This heater is intended for domestic/
household use only.
• Always ensure that this heater is installed as per
the requirements noted in Australian Standard
AS/NZS 3000:2007.
• Always keep heater at least one metre (1m)
from combustible materials.
• DO NOT locate this heater directly below,
above or in front of the power supply socket
or switch.
• DO NOT use this heater within 1 metre
or above any water source.
• DO NOT use this heater in either the
bathroom or ensuite without suitable
ventilation.
• DO NOT use a 3rd party timer, or
programmable system with this heater.
• DO NOT clean the heater while the heater is
on or plugged into the mains power supply.
• DO NOT touch any part of the heater while
on, hot surfaces may burn.
• DO NOT use the wall heater as a dryer.
• DO NOT attempt to modify the heater,
power cord, power plug or the supplied
accessories in any way.
• DO NOT expose the heater to rain, water, or
use in damp wet conditions.
• NEVER cover this heater.
• NEVER carry the heater by its power supply cord.
• NEVER use with the power cord coiled,
bundled up or tied up. Always extend fully
before use.
• NEVER use the heater if any part of it is
damaged.
• Ensure that the heater is disconnected from
the mains supply when installing, cleaning
or removing/installing.
• Ensure this heater is not left on when
unattended.
• Ensure the heater is not used in areas
where flammable gases are present, e.g.
paint, petrol etc.
• Always turn the heater OFF at the unit
switch and the power point switch when not
in use for extended periods of time.
• Always allow the heater to cool, about one
(1) hour after the heater has been turned
off, before cleaning the heater.
• Always ensure that the power cord is fully
extended and NOT in contact with any part
of the heater.
• Always ensure that the heater is kept clean
and free from dust.
• Only use this heater when securely attached
to the wall/ceiling.
• If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order
to avoid a hazard.
•
CAUTIoN — Some parts of this product
can become very hot and cause burns.
particular attention has to be given
where children and vulnerable people
are present.
• WARNING: In order to avoid overheating,
do not cover the heater.
• WARNING: This heater is not equipped with
a device to control the room temperature.
Do not use this heater in small rooms when
they are occupied by persons not capable
of leaving the room on their own, unless
constant supervision is provided.
