3
2
INSTALLATIoN, opERATIoN &
MAINTENANCE INSTRUCTIoNS
Safety
Before attempting to operate this heater, the
following basic safety precautions should be
taken to reduce the risk of fire, electric shock
and personal injury. It is important to read
the instruction manual and to understand its’
applications, limitations and potential hazards
associated with this heater. This heater is not
intended for use by persons (including children)
with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge,
unless they have been given supervision or
instruction concerning the use of the appliance by
a person responsible for their safety. This heater is
not designed for use within 1m or above a water
source. It is important that you read, understand
and follow these instructions very carefully. They
are designed for the safety of yourself and others
ensuring a long and trouble free service life from
your heater. This electric heater complies with
Australian and International standards and safety
requirements. Repairs should only be carried out
by qualified persons using original spare parts.
Failure to do so may result in considerable danger
to the operator.
Safe operation
Beware of Children and pets
Children should not be allowed to touch or operate
heaters or touch extension cords, if used. All
heaters should be kept out of reach of children,
preferably stored or locked in a secure cabinet or
room when not in use.
Do Not Abuse the power Cord
Never yank or pull on the power cord to disconnect
it from the mains supply socket. Never carry your
heater by its’ power cord. Keep the power cord
away from heat, oil, solvents and sharp edges.
Check the power cord regularly for any damage
and if the power cord becomes damaged have it
replaced by an authorised service facility.
Extension Cords and Reels
This heater is NOT designed to run off an
extension cord. If you require an additional power
point please have one installed by a qualified
electrician.
The use of extension cords may cause power
voltage loss which will result in damage to the
motor this will NOT be covered under warranty.
Installation
Always ensure you select the correct fixing
accessories which suit the particular wall/ceiling
material you are attaching to, if in doubt please
discuss with your local retailer or local hardware
store. This heater is not designed for use within
1m or above a water source. All installations must
meet the requirements of Australia Standard
AS/NZS 3000:2007.
Ensure that the heater is not positioned directly
above, below or in front of a power point or
switch.
This heater is not designed to be used with 3rd
party timer or programmable system.
FoR yoUR SAFETy
WARNING: Fire risk exists if this heater is
covered by or positioned close to curtains or
other combustible materials.
NOTE: If using this heater outside ensure that
it is connected directly to an outdoor power
point.
The electrical system of this heater must be
connected with an automatic 30mA circuit
breaker and/or residual current device (RCD).
If uncertain have a qualified electrician check
your electrical system before installation and/
or use.
All electrical connections are made in a dry
area.
Outdoor power points must be weatherproof
and installed by a qualified electrician.
Sitro Group Australia Pty Ltd is not responsible
for incorrectly chosen fixing accessories or
any damage which may be caused by an
incorrectly fitted wall heater.
If required 15AMP power points must be
installed by a qualified electrician.
For any queries or assistance call
Customer Service
Australia only
1300 174 876
Hours of operation:
Monday to Friday 8:00am - 5:00pm EST
Do not return to place of purchase.
Keep your purchase receipt, this will be
required to make any claims under the 12
month warranty.
