Gasmac GARAGEMAC GM-40S, Installation & Operating Instructions Manual

Page: 32 / 44

32
RECOMMENDED MAINTENANCE
WARNING
Improper adjustment, alteration, service or maintenance can cause property
damage, injury or death.
This heater must be installed and serviced only by a
trained gas service technician.
 Carry out these steps at a minimum prior to every heating season. It is
recommended that they be conducted routinely throughout the heating season as
well.

Inspect the entire heater system; venting and gas supply connections. Replace
worn parts and contact a qualified gas technician to repair deficiencies.
 Check the combustion air inlet and the blower, cleaning off any lint or foreign
matter that has accumulated. It is important that the flow of combustion and
ventilation air must not be obstructed.

Check the exhaust termination for obstruction. Clear as required.

Visually inspect the reflector and tube assembly for dust/debris/damage. Clean
and/or service as required.

Run the appliance through a full cycle, verifying that all steps outlined in the
Operating Sequence are progressing as outlined. If any aberrant behavior or
appliance failures occur, contact a qualified gas technician for service.
The tube heater burner is completely factory assembled and tested. Any alteration voids
the certification and manufacturer’s warranty. For additional information, contact your
local distributor, or the manufacturer.
WARRANTY
ALL Gasmac heaters are covered by a 4 year guarantee. All heaters manufactured by
Gasmac are warranted to the original user against defects in materials and
workmanship under normal use for a period of 4 years from date of purchase. Gasmac
tubes are covered by a 20-year warranty against burn out. Any part that is determined
to be defective in material or workmanship during the warranty period, and returned to
the manufacturer, shipping costs prepaid, will be, as the exclusive remedy, repaired or
replaced at the discretion of the manufacturer. For warranty claim procedures see
“Prompt Disposition of Warranty Claims” below.
To the extent allowable under applicable law, the manufacturer’s liability for
consequential or incidental damages is expressly disclaimed. The manufacturer’s
liability in all events is limited to and shall not exceed the purchase price paid.
Many jurisdictions have codes and regulations governing sales, construction,
installation, and/or use of products for certain purposes, which may vary among
jurisdictions. While the manufacturer attempts to assure that its products comply with
these many codes, it cannot guarantee compliance, or cannot be responsible for how
the product is installed or used. Before purchase or use of a product, review the
product applications, and all applicable national and local codes and regulations, and
ensure that the product and installation will comply with them.