www.gaslandchef.com
3330-A Marathon Ct Charleston, SC 29418
11
1 (844) 538-7890
Troubleshooting Guide
Exploded View
Problem
Burner fails to ignite
No spark created when
ignited
1. Incorrect igniter electrode position.
2. Electrode damaged or broken.
3. Loose or disconnected igniter wire.
4. Broken igniter wire.
1. Properly position electrode
2. Replace the electrode.
3. Tighten or reconnect loose wire.
4. Replace igniter wire.
Heater stops running by
itself
1. Thermocouple damaged
2. Gas control valve damaged.
3. Gas leak
4. Thermocouple not in contact with
pilot flame.
5. Tip-over switch damaged, or loose
connection at tipswitch.
6. Out of fuel.
1. Replace entire heater
2. Replace gas control valve.
3. Check all connections for leaks using 50/50
solution of dish soap and water. Repair any
leaks found.
4. Clean inside of heater housing.
5. Inspect tip-over switch and connections.
Replace if necessary.
6. Replace LP cylinder
1. Air in gas line
2. Gas pressure from cylinder too low.
3. LP cylinder valve turned off
4. Obstruction in air passageway.
5. Dirt in pilot orifice.
6. Safety switch in cylinder valve
engaged.
7. Tipover switch engaged.
Possible Cause
1. Keep depressing the gas control knob for at
least 30 seconds to remove any in line.
2. Check LP cylinder pressure. Tank may be
empty.
3. Open LP cylinder valve.
4. Inspect and clean heater housing.
5. Blow out, or clean pilot orifice.
6. Close LP cylinder valve. Wait 1 min. for switch
to click off. Reopen LP cylinder valve slowly.
7. Move heater to a level surface.
Solution
