Connection cable (6 core cable) is defined as
follows:
4-20mA with RS485:
Red: positive-input of power (12 to 24V)/ 24V+
Black:
ground wire of power/24V
Yellow:4-20mA output.
Orange: RS485A
Blue: RS485B
Brown: Free
Connection distance: >1000m
Protection grade: IP65
Installation type: on wall
Type of explosion-proof: flame proof
Explosion-proof
grade: Ex d IIC T6 Gb
Inlet port: hexagonal locknut
Settings of Remote Control
The remote control applied to all product type produced by Yuante.
1. Press "MENU" once to enter F01, address code setting menu. Press "OK" to modify, press"+""-
"to modify address code of the detector. Press "OK" to save settings and "BACK" to cancel.
2. Press "MENU", then press “+”to enter F02, minimum value setting menu of gas alarm, Press
"OK" to modify, press"+" "-"to modify the value. Press "OK" to save settings and "BACK" to cancel.
3. Continue to press "+"to enter F03, maximum value setting menu of gas alarm., Press "OK" to
modify, press"+" "-"to modify the value. Press "OK" to save settings and "BACK" to cancel. Same operation with
F04 (zero point calibration), F05 (range calibration), F06 (AD value).
4. Press "MENU" four times to enter a shift status, under this status:
Press "RESET" once, the data would be 255, one more it would be 0. Just press "RESET" to shift. When the
data is 0, press "+"or"-"to modify alarm point, the data difference would be only 1. When the data is 255, press
"+"or"-"to modify alarm point, the data difference would be 1000. "RESET" can also be used as mute button
when it is alarming.
MENU
RESET
OK
+
BACK
-
MENU button, from the measurement state into the functional state alarm
reset to eliminate alarm function
confirm button
plus
return
minus
Remote controller function
www.gasdog.com
+86 773-280-9002
8