GAS GAS MC 250F FACTORY EDITION 2023, Owner'S Manual

Page: 42 / 148

10 TUNING THE CHASSIS
40
F03627-10
Main work
–
Loosen screw
1
.
–
Turn adjusting ring
2
until the spring is no longer under tension.
Hook wrench (90129051000)
Info
If the spring cannot be fully released, the spring must be
removed to accurately measure the spring length.
–
Measure the total spring length while the spring is not under ten-
sion.
–
Tension the spring by turning adjusting ring
2
to specified dimen-
sion
A
.
Guideline
Spring preload 8 mm (0.31 in)
Info
Depending on the static sag and/or the riding sag, it may be
necessary to increase or decrease the spring preload.
–
Tighten bolt
1
.
Guideline
Screw, shock absorber
adjusting ring
M5 5 Nm (3.7 lbf ft)
Finishing work
–
Install the shock absorber. ( p. 59)
–
Check the free travel of the foot brake lever. ( p. 86)
–
Install the main silencer. ( p. 67)
–
Install the right side panel. ( p. 62)
–
Install the frame protector. ( p. 50)
–
Remove the motorcycle from the lift stand. ( p. 47)
10.11 Adjusting the riding sag
Preparatory work
–
Raise the motorcycle with a lift stand. ( p. 47)
–
Remove the frame protector. ( p. 50)
–
Remove the right side panel. ( p. 62)
–
Remove main silencer. ( p. 66)
–
Remove the shock absorber. ( p. 58)
–
After removing the shock absorber, clean it thoroughly.
B00292-10
Main work
–
Choose and mount a suitable spring.