GAS GAS 2005 EC ROOKIE, Service Manual

Page: 29 / 40

-
27
-
FINAL THINKS
PREVENTIVE ADVICE
Periodic maintenance and thorough checking of every function before
starting the moped. Periodic checking operations of this moped must
only be carried out by GAS GAS After-Sales specialists.
SAFE USE OF THIS MOPED
Safe use of a moped does not only depend on the vehicle. Here,
the rider’s common sense and intelligence play a crucial role.
Therefore, we recommend that you wear the required gear (helmet,
boots, etc.) to practise your favourite sport.
In the interest of technical development, we reserve the right to
modify the construction, standard equipment and accessories of this
moped. Data concerning measurements, weights and power includes
the relevant tolerances.
Depending on the equipment and accessories included with this
moped, as well as on the various versions designed for world markets,
there may be differences between this vehicle and the descriptions
and illustrations supplied. Because of this, errors and omissions
excepted, no claims will be accepted in this connection.
GAS GAS MOTOS, S.A. reserves the right to introduce changes and / or modifications
without prior warning.
STORAGE
Proceed as follows, before storing the moped for some time:
- Clean the moped thoroughly.
- Start the engine and keep it running for approximately 5 minutes
to heat the transmission oil, then drain it (see the Transmission
section).
- Refill with new oil.
- Drain the petrol tank (if left in the tank for a long time, petrol loses
quality).
- Disconnect the battery.
- Lubricate the chain and all the cables.
- Apply oil on all non-sprayed metal surfaces to prevent rust, but not
on the brakes or rubber parts.
- Wrap the outside of the exhaust pipe in a plastic bag to prevent
rust.
- Place the moped in such a way as to avoid contact of the wheels
with the ground (if this is not possible, place some cardboard under
the wheels).
- Cover the moped to avoid dust and dirt.
Starting the moped after a period in storage:
- Remove the plastic bag from the exhaust pipe.
- Tighten the sparking plug.
- Fill the petrol tank.
- Check the steps set forth in the section entitled "Inspection prior
to using the moped".
- General lubrication.
- Connect the battery.
- Check tyre pressure.