© ANITA
MP04700EN_200120
GF-1115-147 LM, GF-1115-447 MH
4
SAFETY INSTRUCTION
1) Users are required to read the operation manual completely and carefully before installation or
operation.
2) The product should be installed and pre-operated by well trained persons
3) All the instruction marked with sign
，
must be observed or executed; otherwise, bodily injuries
might occur.
4) For perfect operation and safety, it is prohibited that using extension cable with multi-outlet for
power connection
5) When connecting power supply cords to power sources, it is necessary to make sure that the
power voltage is lower than 250V AC and matches the rated voltage indicated on the motor’s name
plate.
Attention:
If the Control Box is AC 220V system, please don’t connect the Control Box to AC
380V power
outlet. Otherwise, the error will occur and motor will not work. If that happens, please turn off the
power immediately and check the power voltage. Continue supply 380V power over 5 minutes
might damage the fuse F2, burst the electrolytic capacitors and the power module U14 of the main
board and even might endanger the person safety.
6) Please don’t operate in direct sun light, outdoors area and where the room temperature is over
45
°C or below 0°C.
7) Please avoid operating near the heater at dew area or at the humidity below 10% or above 95%.
8) Please don’t operate in area with heavy dust, corrosive substance or volatile gas.
9) Avoid power cord being applied by heavy objects or excessive force, or over bend.
10) The earth wire of power cord must be connected to the system ground of the production plant
by proper size of conductions and terminals. This connection should be fixed permanently.
11) All the moving portions must be prevented to be exposed by the parts provided.
12) Turing on the machine in the first time, operate the sewing machine at low speed and check the
correct rotation direction.
13) Turn off the power before the following operation:
1. Connecting or disconnecting any connectors on the control box or motor.
2. Threading needle.
3. Raising the machine arm.
4. Repairing or doing any mechanical adjustment.
5. Machine is out of work.
14) Repairing and high level maintenance work should only be done by electronic technicians with
appropriate training.
www.garudan.cz
