© ANITA
MP04700EN_200120
GF-1115-147 LM, GF-1115-447 MH
8
2. ERROR CODE LIST
E01
Over-voltage
Turn off the machine, check the power supply voltage.(Or whether
exceed the rated voltage of use). If there are still errors, please replace
the control box and call for customer service.
E02
Low-voltage
Turn off the machine, check the power supply voltage.(Or whether under
the rated voltage of use). If there are still errors, please replace the
control box and call for customer service.
E03
CPU communication
error
Turn off the machine, please check if the operation panel in bad
connection or is too loose. To get it right and turn on. If there are still
errors, please replace the control box and call for customer service.
E05
Pedal connection
error
Turn off the machine, please check if the pedal in bad connection or is
too loose. To get it right and turn on. If there are still errors, please
replace the control box and call for customer service.
E07
Motor locked-rotor
error
Turn the machine hand wheel, check if it is stuck. If it is stuck, you have to
rule out the mechanical failure. If turn normal, check if the encoder and
motor in bad connection or is too loose. If yes, please correct. If
connection well, check if the power supply voltage is abnormal or sewing
speed is too high. If yes, please adjust. If there are still errors, please
replace the control box and call for customer service.
E08
Manual reverse
feeding operation
more than 15 seconds
Back-Tacking electromagnet response time is too long, you have only to
restart the machine. If there are still errors E-08 after restart the
machine, check if the manual reverse feeding switch is damaged.
E09
E011
Positioning signal
error
Turn off the machine, please check if the encoder in bad connection or is
too loose. To get it right and turn on. If there are still errors, please
replace the control box and call for customer service.
E10
Solenoid over-current
Turn off the machine, please check the related circuit is shorted or
damaged.
E14
Encoder error
Turn off the machine, please check if the encoder in bad connection or is
too loose. To get it right and turn on. If there are still errors, please
replace the control box and call for customer service.
E15
Power supply module
abnormal over-
current
Turn off the machine, then turn on again. If there are still errors, please
replace the control box and call for customer service.
E17
Machine protection
switch is not in the
correct position
Turn off the machine, check if the machine is turn over, or the Mercury
Switch is shifted or damaged.
E20
Motor failed to
start(Electrical angle
error)
Turn off the machine, please check if the encoder and motor in bad
connection or is too loose. To get it right and turn on. If there are still
errors, please replace the control box and call for customer service.
Oil
Low oil
Turn off the machine, check if the oil is too little. To fill it up and turn on.
If there are still errors, please replace the control box and call for
customer service.
www.garudan.cz
