Magnum 6K25 Managed Fiber Switch Installation and User Guide (04/06)
36
www GarrettCom com
.
.
4.0 OPERATION
This chapter describes the functions and operation of the Magnum 6K25
Switch.
4.1 Switching
Functionality
A
Magnum 6K25 provides switched connectivity at Ethernet wire-speed
among all of its ports. The Magnum 6K25 supports10/100Mbs for copper media and 10
or 100Mb separate traffic domains for fiber ports to maximize bandwidth utilization and
network performance. All ports can communicate to all other ports in a Magnum 6K25,
but local traffic on a port will not consume any of the bandwidth on any other port.
Magnum 6K25 units are plug-and-play devices. There is no software
configuring necessary to be done for basic operation at installation or for maintenance.
The only hardware configuration settings are user options for an UP-LINK Switch
(resides inside the unit) on the 6K8-RJ45. Optional Half / Full duplex mode and 10 or
100Mbps selection for the switched ports must be configured through MNS software per
unit as per the requirement. The internal functions of both are described below.
Filtering and Forwarding
Each time a packet arrives on one of the switched ports, the decision is taken to
either filter or to forward the packet. Packets whose source and destination addresses are
on the same port segment will be filtered, constraining them to that one port and relieving
the rest of the network from having to process them. A packet whose destination address
is on another port segment will be forwarded to the appropriate port, and will not be sent
to the other ports where it is not needed. Traffic needed for maintaining the operation of
the network (such as occasional multi-cast packets) are forwarded to all ports.
The Magnum 6K25 Switches operate in the store-and-forward switching mode,
which eliminates bad packets and enables peak performance to be achieved when there is
heavy traffic on the network.
Address Learning
All
Magnum 6K25 units have address table capacities of 4K node addresses
suitable for use in larger networks. They are self-learning, so as nodes are added,
removed or moved from one segment to another, the 6K25 Switch automatically keeps
up with node locations.
An address-aging algorithm causes least-used addresses to fall out in favor of
frequently-used addresses. To reset the address buffer, cycle power down-and-up.
