FEATURES
continued
4.
IRON CANCEL
- Tap to silence hot rocks, trash and mineral changes in
both audio modes. Hold to adjust the Iron Cancel setting (tap the
button to cancel high-wrap hot rocks). Note that this setting may decrease the
detector’s sensitivity to very small gold, but is necessary in difficult ground
conditions.
5.
VOLUME and THRESHOLD
- Tap to adjust the volume with the up and
down buttons. Press and hold for one second to adjust the threshold with
the up and down buttons (“th” displays on the screen). With the volume at
levels over 8 you can enable Boost
1
and Boost
2
for maximum sensitivity.
6.
AUDIO MODE
- With the displayed on screen, the detector is in “BEEP”
audio mode (high tone = good target, low tone = bad target). The default
setting (without on screen) is a traditional All-Metal audio mode with
greater sensitivity to small targets.
7.
SAT
- SAT can smooth out ground inconsistencies. Press and hold for
one second to adjust it (“Sa” displays on screen,
2
is the default setting).
8.
PINPOINT
- Hold for non-motion pinpoint mode. In difficult ground
this mode may be affected by mineralization.
9.
BACKLIGHT
- Tap to enable the backlight (this reduces battery life).
10.
FREQUENCY SHIFT
- Hold when turning the detector on to shift
frequency (useful when there is EMI). Use and to change frequencies.
Power off to save the selection.
11.
FACTORY RESET
- Hold when turning on the detector. Press and hold
button when “Fd” is on screen to reset the machine to factory default.
FCC COMPLIANCE
CE COMPLIANCE
This device complies with part 15 of the FCC Rules. Operation is subject to the following conditions.
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.
CAUTION: Changes or modifications not expressly approved by Garrett Electronics, Inc. could void your authority to operate this product.
This device operates within the following frequency range and maximum power output:
(a) Frequency band in which the radio equipment operates - 46.696kHz - 47.904kHz
(b) Maximum radio-frequency power transmitted in the frequency band in which the radio equipment operates: 21.57 dBuA/m
The above frequency range and power output is consistent with test report results.
