23
EN
Congratulations on selecting a GARO GLB Wallbox and
contributing to a better environment. The GARO GLB Wallbox is
an AC charge-station enabling Mode 3 charging which complies
fully with the requirements of IEC 61851-1 and IEC TS 61439-7.
The product complies with IP Code IP44, with a closed front. It is
to be fitted to a wall or GARO Wallbox stand, and all installation
must be carried out by an authorized installer and comply with
local country installation regulations.
NOTE! Read all safety information before you start to use the GLB
Wallbox
USER INSTRUCTIONS
Charging electric vehicles
1. Connect the GLB Wallbox to the vehicle using the cable.
2. When charging starts, shifting blue light intensity indicates
charging in progress.
3. Stop charging. As a rule, the GLB Wallbox socket and vehicle
inlet locks the cable. As a result, charging must be stopped from
the vehicle before the cable is removed. Terminate charging
according to the vehicles instruction manual, removing connector
from car before removing connector at charger end.
4. After terminated charging, make sure cable is suspended.
Important information:
• It is your EV that decide how much energy the GLB Wallbox
deliver to the EV.
• The GLB Wallbox can deliver max the kW according to the
GLB Wallbox rating label.
• The EV also check the capacity of the charging cable that you
use, and never exceed the capacity of the charging-cable.
If your GLB Wallbox is equipped with a socket, it is important
to use the right type of cable. For example, to charge at 32A,
a 32A cable is required. There are both 1-phase and 3-phase
cables on the market, make sure you use correct type for your EV.
User instructions
The status of the GLB Wallbox can be obtained from the color of
the Indication light (D).
Solid green light: charger ready, vehicle not
connected.
Flashing green light: device connected to vehicle
eg. status
Rapid flashing green: device waiting for
authorization eg. RFID tag
Shifting blue light intensity: device connected to
vehicle, charging in progress
Solid blue light: RFID accepted - waiting to start
charging
Red/yellow light: fault. Refer to selection on
Troubleshooting
Sound indications:
• Up beat tone: Charger power up or begin charging process.
• Down beat tone: Charger fault.
• Ticking tone: device waiting for authorization eg. RFID tag.
D
(figure 22)
(figure 23)
