Installing the Transducer Using Low-Profile Mounting Hardware
If you do not plan to change the viewing mode of the transducer often, or prefer a lower-profile installation
without the adjustment knob, you can use the included low-profile hardware.
1 Install the mounting bracket but do not use the included adjustment knob (
Installing the Transducer on the
Garmin Ice Fishing Pole Mount, page 5
).
2 Instead of using the knob, use the low-profile screw and metal washer to secure the transducer to
the mounting bracket.
3 Adjust the view of the transducer and tighten the low-profile screw using the included hex wrench.
Connecting and Stowing the Cables
CAUTION
Ensure that you connect the correct spade connector to the correct battery terminal. Damage to the battery or
device, or bodily harm may occur if the device is improperly connected to the battery.
NOTE: The gray + and - connectors on the power cable are for connecting to an optional PS22 transducer.
1 Connect the 4-pin power cable and network cable to the chartplotter.
2 If you are connecting an optional PS22 transducer, connect the power leads to the gray bare wire connectors
on the power cable.
3 Slide the positive (red) spade connector onto the positive (red) terminal on the battery.
4 Slide the negative (black) spade connector onto the negative (black) terminal on the battery.
5 If necessary, wrap excess any excess cable around the hooks on the sides of the handle on the portable
mount.
8
