Attaching the Bail Mount
You need a Phillips screwdriver to attach the bail mount to the portable mount.
1 Align the chartplotter bail mount over the hole pattern that matches your bail mount, with the openings on
the top of the bail mount facing the back of the base.
2 Secure the bail mount to the base using the four included 24 mm machine screws and the included
washers, if you are installing a metal bail mount.
NOTICE
If you are installing a metal bail mount, use the included washers to protect and reinforce the base. If you are
installing a plastic bail mount, you do not need to use the washers.
NOTE: Do not use the self-threading screws included with the chartplotter. Only use the machine-threaded
screws included with this portable kit or use M4 machine screws.
3 Place the included rubber washers on the bail-mount knobs , and screw the knobs into the sides of the
cradle or chartplotter.
4 Place the cradle or chartplotter into the bail mount, with the rubber washers between the knobs and the
cradle or chartplotter, and tighten the knobs.
The rubber washers enable you to adjust the viewing angle without adjusting the knobs.
3
