Installing the Transducer on the Garmin Ice Fishing Pole Mount
CAUTION
Keep the transducer cable secure. Failure to do so could create a trip and fall hazard, which could result in
personal injury.
NOTICE
You can use electrical tape or cable ties to secure the transducer cable. If you use cable ties, do not over-tighten
them. Over-tightening cable ties can damage the cable and cause transducer failure.
NOTE: If you do not plan to change the viewing mode of the transducer often or prefer a lower-profile
installation without the adjustment knob, you can use the included low-profile hardware (
Transducer Using Low-Profile Mounting Hardware, page 8
).
TIP: The top of the transducer must be below the bottom of the ice for best performance.
To install the transducer on the Garmin Ice Fishing Pole Mount, you need the included hardware and hex
wrench.
1 If the pole is equal to or less than 25 mm (1 in.) in diameter,
wrap the rubber liner around the pole at the mounting
location.
2 Place the halves of the shaft-mount bracket around the
rubber liner at the mounting location.
3 Insert the screws into the shaft mount bracket, and secure
them using the hex wrench.
5
