Garmin GTN 625, Installation Manual

Page: 146 / 254

GTN 625/635/650 TSO Installation Manual 190-01004-02
Page 6-36 Rev. F
6.9.2.3 Stormscope
®
Download Data Page
Select the ‘Download Data’ key from the Stormscope page. This page shows raw data downloadable from
the WX-500. Optional sets of data include WX-500 software version, configuration data, environment
data, and fault log data.
Verify that the configuration data is correct as intended. To request which packet of data to display, touch
the key underneath ‘Data to Display’ and select a data type from the menu.
6.9.3 Traffic Test Page
NOTE
The following pages are only available if
one of the ARINC 429 inputs is configured
for a traffic format.
Access the Traffic Test page, as shown in

Figure 6-39 by touching the ‘Traffic’ key on the
External Systems page. The traffic page displays the
traffic system modes of operation and current traffic situation. The following pages are only available if
one of the ARINC 429 or RS-232 inputs configured is for a traffic format or the GDL 88 is interfaced to
the GTN.
Depending on the type of traffic system installed, the information displayed on the Traffic Test Page can
vary.
6.9.3.1 Ryan TCAD
For Ryan TCAD, the Traffic Test page displays the following data:
 Current Shield Mode
 Altitude Filter - Normal, Above, Below and Unrestricted
 Barometric Pressure
By touching the ‘Menu’ key, the traffic menu can be displayed. Under Traffic Audio, the mute duration
(9900B only) and traffic audio volume can be set and the TCAD can be toggled between voice and tone
alerts. Under Shield Setup, the shield settings can be configured for the various shield types. Also, Ground
Mode (9900BX only) and APPR Mode can be toggled.
6.9.3.2 Other Traffic Systems
For traffic systems other than Ryan TCAD, the Traffic Test page displays the following data:
 Altitude Filter - Normal, Above, Below, and Unrestricted
 Operating Mode - Standby, Operate, or TAS Fail
 Altitude
 Heading
 BARO Alt and RAD Alt status
Figure 6-39. Traffic Test Page