0
GPSMAP 4000 Series Owner’s Manual
V
ie
W
in
G
i
nforma
tion
Viewing Fuel Gauges
To view fuel gauges from the Home screen, select
Information
>
Fuel
. Fuel flow for each engine,
total fuel flow, fuel level in each tank, total fuel remaining, fuel economy, and the range for your
boat are shown.
NOTE:
To view fuel information, your unit must be connected to an external fuel sensor, such as the
Garmin GFS 10.
To synchronize your fuel gauges with your fuel:
From the Home screen select
Information
>
Fuel
>
Menu
.
Fill Up All Tanks
—Select when your tank is full. An estimate of the total fuel is shown. Adjust
if necessary.
Add Fuel To Boat
—Select when you have added less than a full tank. An estimate of the fuel
added is shown. Adjust if necessary.
Set Total Fuel Onboard
—Select to specify the total fuel in your tanks.
Econ Source
—Select to specify the speed source (GPS Speed or Water Speed) for the Fuel
Economy gauge.
Reset Odometer
—Select to reset the odometer (located on the speedometer).
Viewing Video
Your unit can display video if you connect to a video source (or sources) using the supplied video
cable. See the
GPSMAP 4000/5000 Series Installation Instructions
for details.
To view video from the Home screen, select
Information
>
Video
.
Select
Menu
to setup the following:
Source
—selects the video device (Video 1 or Video 2) that will display the video. If you have
two video sources and wish to alternate between the two, select
Alternate
to define the amount
of time each video is displayed.
Aspect
—switches between the standard aspect ratio and a stretched aspect ratio. The video
cannot be stretched beyond the dimensions provided by the connected video device. Because of
this, the stretched video may not fill the entire screen of the GPSMAP 4212 chartplotter.
Brightness
—adjusts the brightness of the video feed up or down. Select
Auto
to allow the unit to
automatically adjust the brightness.
Saturation
—adjusts the color saturation up or down. Select
Auto
to allow the unit to
automatically adjust the saturation.
Contrast
—
adjusts the contrast up or down. Select
Auto
to allow the unit to automatically adjust
the contrast.
Standard
—selects the video format used by the source (PAL or NTSC). Select
Auto
to let the
unit automatically select the source format.
•
•
•
•
•
•
•
•
•
•
•
