GPS 155XL/GNC 300XL Installation Manual
P/N 190-00067-22 Rev E Page 3-4
3.7
CABLE INSTALLATION
1. Route the coaxial cable to the rack location keeping in mind the recommendations of Section 2. Secure
the cable in accordance with good mechanical practices.
2. Trim the coaxial cable to the desired length and install the BNC connector (330-0087-00) per the cabling
instructions in Figure 3-1. If the connector is provided by the installer, follow the connector
manufacturer's instructions for cable preparation.
3. Contacts for the 37 and 26 pin connectors must be crimped into the individual wires of the aircraft wiring
harness.
Table 3-1 lists contact part numbers (for reference) and crimp tools.
Table 3-1. Contact Part Numbers and Recommended Crimp Tools
Notes regarding the table:
•
Insert/Extract tools from ITT Cannon are all plastic, others are plastic with metal tip.
•
Non-GARMIN part numbers shown are not maintained by GARMIN and consequently are subject to
change without notice.
•
Alternate contacts for 18 AWG wire: As an alternate to the Positronic contacts listed (and provided in the
install kit), the installer may use contacts made by ITT Cannon as follows:
