Garmin GNS 530W, Installation Manual

Page: 86 / 216

Page 5-8 500W Series Installation Manual
Rev. D 190-00357-02
COM Presets (Main software version 3.00 or later)
Selection Description
Disabled
The COM Configuration Aux page is not available to the pilot.
Enabled The COM Remote Recall discrete input is connected in the installation
(refer to 4.5.1.16 for additional details). When COM presets are
enabled, the user is able to preset COM frequencies and load them
into the standby COM frequency using a remote switch.
5.3.4 MAIN INPUTS Page
Select the MAIN INPUTS page (see Figure 5-6). This page allows you to monitor the data on ARINC
429, RS-232 and other electrical inputs. This is used for verifying electrical interfaces during installation
and troubleshooting. Information that is not being received by the 500W Series unit is dashed out.
Field Description
OAT
Outside Air Temperature
SAT Static Air Temperature
TAT
Total Air Temperature
IAS Indicated Airspeed
TAS
True Airspeed
W SPD
Wind Speed
HDG True Heading
W DIR
Wind Direction
GPS SC
GPS Selected Course
VLC SC
VOR/LOC Selected Course (GNS 530W
Only)
CDI Status of the CDI key (GNS 530W Only).
B ALT
Barometric-corrected Altitude
D ALT Density Altitude
P ALT
Pressure Altitude
L FF Left Engine Fuel Flow
R FF Right Engine Fuel Flow
T FF
Total Fuel Flow
T FOB Total Fuel on Board
JOYSTICK
WPT
Latitude and longitude of a joystick waypoint
sent by an EFIS or RADAR indicator.
5.3.5 INSTRUMENT PANEL SELF-TEST Page
Select the INSTRUMENT PANEL SELF-TEST page (see
Figure 5-7). This page allows verification that the 500W
Series unit is communicating properly with other
instruments. Compare on-screen indications with the
information depicted on connected instruments, such as the
CDI, HSI, RMI and/or external annunciators. It also
displays fuel capacity, amount on-board, and flow.
Figure 5-6. MAIN INPUTS Page
Figure 5-7. INSTRUMENT PANEL SELF-
TEST Page