8
GHP 10 Installation Instructions
Single-helm Layout Guidelines
NMEA 2000 network
➋
➊
➌
➍
➎
NOTE:
This diagram is for planning purposes only. Specific connection diagrams are included in the detailed installation instructions for each
component. Hydraulic connections are not shown in this diagram.
Item Description
Important Considerations
➊
GHC 10
In order for the autopilot to turn on, the yellow wire from the GHC 10 data cable must be connected to the yellow wire
from the CCU/ECU interconnect cable, and the black wire from the GHC 10 data cable must be connected to the
same ground as the ECU (
).
➋
CCU
The CCU must be installed in the front half of the boat, no higher than 10 ft. (3 m) above the waterline.
➌
NMEA 2000 network The GHC 10 and the CCU must be connected to the NMEA 2000 network using the included T-connectors (
).
If there is not an existing NMEA 2000 network on your boat, you can build one using the supplied cables and
).
➍
12-24 Vdc battery
The ECU can be connected to a 12–24 Vdc power source.
The NMEA 2000 power cable must be connected to a 9–16 Vdc power source.
➎
ECU
The ECU can be connected to either a 12 or a 24 Vdc battery.
Summary of Contents for GHP 10 Marine Autopilot System
Page 24: ......