11
6. Mounting Instructions
CAUTION!
THE BATTERY TAMPER BUTTON MUST BE HELD
DOWN IN THE BATTERY COMPARTMENT BY THE BATTERY,
TO ENSURE THE BATTERY DOOR WILL CLOSE, THE AC QUICK
CONNECTOR WILL ATTACH TO THE ALARM, AND THE ALARM
WILL ATTACH TO THE TRIM RING.
NOTE: PLEASE ENSURE THAT BATTERY IS INSTALLED PRIOR
TO MOUNTING OF HEAT ALARM.
A trim ring is provided on the back of the heat alarm. This trim ring is
removed by holding the trim ring and twisting the heat alarm in the
direction indicated by the TURN TO REMOVE arrow. The trim ring is
secured to the heat alarm by a trim lever.
CAUTION ! THE COVER IS A SEALED UNIT AND HAS NO
REMOVABLE SERVICEABLE PARTS! DO NOT TAMPER.
1. Secure a suitable junction box near the position of the heat alarm,
ensure the quick connect cable
length is long enough to reach
the junction box for termination
to be made.
2. Connect active, neutral and switch
line to the heat alarm cable using
the terminal connection block
provided. Secure these terminals
inside the junction box.
3. Punch out the suitable fixing holes
on the trim ring and then pull the
AC connector through the centre
of the trim ring.
4. Secure the trim ring to the ceiling
using the fixing holes provided.
Connect the 9V battery (back up)
into the battery compartment. If
the back up 9V battery is already
loaded in the battery compartment,
pull out the battery pull tab. Ensure
the locks on the AC connector
snap firmly into place.
SQUEEZE
CONNECTOR
LOCKING
ARMS AND PULL
INSTALL
MARKS
REMOVE
FIGURE 4A
FIGURE 4B
