Garland moisture+ MPOE5, Service Manual

Page: 23 / 28

Document #MPOELSVC0504 Page 23
SERVICE PROCEDURES
Door Micro Switch Service / Removal
1. Open the oven door.
2. Locate and remove the 2 machine screws located
in the upper LEFT side of the cavity frame. (These
screws are just RIGHT of the upper door post on
the cavity door frame.)
3. Remove both screws. DO NOT TOUCH THE
COUNTERSINK SCREW.
4. Remove the 2 screws holding the door micro switch
cover. This is located on the front LH side of the
oven top panel.
5. There will be a small bracket exposed. This bracket
holds the 2 micro switches. Pull the bracket toward
you.
6. Upper switch on bracket is SW2, lower switch is
SW1.
7. Replace required
micro switch.
8. Reinstall door
switches and bracket
and screws.
9. Test door switch
activation /
operation as
indicated in
DIAGNOSTIC
MODE.
Oven Temperature Probe Service/Removal
The probe is located on the interior RIGHT rear side
of the oven cavity.
1. To first gain access to the temperature probe, remove
the oven racks, rack support guides and baffle plate
Remove the 2 screws holding the probe in place
DO NOT REMOVE THE PROBE at this point.
2. The wires for the probe are located behind the
RIGHT side panel.
3. To gain access, remove the screws holding the panel
in place.
4. Pull the panel towards the back of the oven to
remove.
5. Cavity probe is located ABOVE and to the RIGHT
of the cavity motor.
6. Disconnect the 2 BROWN probe wires at the
temperature probe.
7. The probe can now be removed from inside the
oven.
������������
���
�����������
�����������
�����������
�����������
��������������
���������