![background image](http://html1.mh-extra.com/html/garland/gtxhp36/gtxhp36_installation-operation-and-maintenance-manual_3668529005.webp)
Document #: GAR_IOM_4605246 – 1/21
5
n
Warning
Do not use electrical appliances or accessories other than
those supplied by the manufacturer.
n
Warning
This equipment must be positioned so that the plug is
accessible unless other means for disconnection from the
power supply (e.g., circuit breaker or disconnect switch)
is provided.
n
Warning
Disconnect electric power at the main power disconnect
for all equipment being serviced. Observe correct polarity
of incoming line voltage. Incorrect polarity can lead to
erratic operation.
n
Warning
Ensure the input power cable has a slight curve, and is
not ever stretched.
n
Warning
Never touch anything that runs on electricity when your
hands are wet.
n
Warning
Electrical Grounding Instructions
This appliance is equipped with a three-prong (grounding)
plug for your protection against shock hazard and should
be plugged directly into a properly grounded three-prong
receptacle. Do not cut or remove the grounding prong
from this plug.
Notice
Wiring diagram is located behind the front control panel
on the appliance.
CODE
n
Warning
Authorized Service Representatives are obligated to follow
industry standard safety procedures, including, but not
limited to, local/national regulations for disconnection
/ lock out / tag out procedures for all utilities including
electric, gas, water and steam.
n
Warning
For an appliance equipped with casters, (1) the installation
shall be made with a connector that complies with the
Standard for
Connectors for Movable Gas Appliances
ANSI Z21.69 • CSA 6.16,
and a quick-disconnect device
that complies with the Standard for
Quick-Disconnect
Devices for Use With Gas Fuel, ANSI Z21.41 • CSA 6.9,
(2)
adequate means must be provided to limit the movement
of the appliance without depending on the connector
and the quick-disconnect device or its associated piping
to limit the appliance movement and (3) the location(s)
where the restraining means may be attached to the
appliance shall be specified.
CLEARANCE
DANGER
To reduce the risk of fire, the equipment is to be
installed in non-combustible surroundings only, with no
combustible material within 18” (457 mm) of the sides,
front or rear of the appliance or within 40 “ (1 m) above
the appliance. The appliance is to be mounted on floors/
counters of noncombustible construction or applicable
equipment stand or refrigerated base.
DANGER
Risk of fire/shock. All minimum clearances must be
maintained. Do not obstruct vents or openings.
n
Warning
Slipping Hazard: Grease from food products will splatter.
The areas surrounding the grill are a slipping hazard due
to the splatter zone. Clean the area surrounding the grill
regularly. Care needs to be taken as equipment may be
hot.
n
Warning
Failure to maintain required clearances and additional
distances as needed can result in INJURY and EQUIPMENT
DAMAGE.
Consult manufacturers’ literature, and sales and service
agencies as needed.
,
Caution
Do not block the supply and return air vents or the air
space around the air vents. Keep plastic wrappings,
paper, labels, etc. from being airborne and lodging in
the vents. Failure to keep the air vents clear will result in
unsatisfactory operation of the system.