Garland BEST 100 DPE, Instruction Manual

Page: 34 / 120

English
34/120
English
35/120
Remember that the end of the nylon threat is the one
that makes the cut. Get a better result if you do not
introduce the entire head in the cutting area.
Enter the head slowly and let the nylon tips cut the
grass at their own pace.
Hold the brush cutter in the way
that the head do not touch the
ground and with an inclination of
20º in the sense you are cutting.
Make cuts from the left to the
right to prevent that the grass
fall into the cutting area. Be
careful to not hit the head
with rocks or the ground. The
beatings against objects or the
ground will reduce the life of
the head, may spoil creating a dangerous environment
for you and the people close to you.
The nylon threads are shortened with the use, when
they are too short accelerate the engine and press the
head against the ground. Then leave wire from the
head. If you leave too much wire the blade will cut in
excess.
WARNING DANGER: Do not operate the brush
cutter in areas with metallic materials. Always use the
proper protective equipment. Don’t use this machine
in areas where you can’t see properly.
7.3. CUT WITH THE DISC
Check the disc holder and make sure it is tight and
there are no signs of damage or abrasion.
Make sure the disc and disc holder are firmly installed
in accordance with the instructions and that the disc
spins freely without producing abnormal sounds.
CUTTING METHOD:
- Cut with the left front of the disc.
- Always cut to the left keeping the disc slightly
inclined to the left.
IMPORTANT:
- Only use this machine to cut grass. Do not let
the disc touch materials that can not cut as stones,
metals, hard wood, wire mesh, etc.
- Keep the blade sharp. A bad sharpened disc cause
a higher cutting force on the machine as well as
increased risk of rebound or projection materials.
- Keep the area to be cut clean with no traces of
chopped vegetables or other materials.
8. MAINTENANCE AND SERVICE
The removal of the security elements, a
poor maintenance or the substitution of
spares and accessories by non original
ones can all cause severe corporal damages.
Always carry out all the maintenance work
with the machine unplugged from the mains.
Always carry out all the maintenance work
with the machine unplugged from the mains.
Attention! The blades do not stop
automatically once the engine has been
stopped. Ensure the cutting element is
at a complete standstill before cleaning,
transporting and changing the cutting element.
8.1. MAINTENANCE AFTER USE
Carry out the following operations when you have
finished the work to ensure that the machine is kept in
a perfect condition.