Garland BEST 100 DPE, Instruction Manual

Page: 32 / 120

English
32/120
English
33/120
Mounting
1. Block both ends of the nylon thread in the two
grooves (B).
2. Reinsert the nylon charge back into place and
place the two extremes of the nylon thread in the
exit holes (A).
3. Pull each nylon thread until it is sticking out some
12 cm .
4. Mount the bump head by turning anticlockwise.
6.3. CHECK POINTS BEFORE STARTING
The current and tension supplied must
coincide with those in the characteristics label.
Prior to starting work check that the machine works
adequately and all security measures work.
Check the machine completely and look for loose
parts (screws, nuts, etc.) and damages. Press, repair or
replace everything you need before using the machine.
Verify that the protective screen is properly attached to
the brush cutter.
6.3.1. FIXING CABLE EXTENSION
Only use cable extensions that are homologated for
outdoor use.
When using a cable extension, make
sure that its minimum section is 1.5 mm 2 and no
longer than 25 metres, always unrolled before
starting to work.
Fix the extension of the tiller by inserting cable in the
hook on the handle and plug onto the machine.
6.4. START UP AND STOPPAGE
Start up the machine:
Press the security button (A) and without letting go,
press the On/Off switch (B)
Stoppage of the machine:
Let go of the On/Off switch (B).
7. MACHINE USAGE
Only use this machine for those jobs for which it
has been designed.
The use of this brush cutter for
other uses is dangerous and could cause damages to
A B
B
A
A
B