Gared Pro-S Portable Backstop
7
IMPORTANT NOTE:
Before proceeding to the next step, make sure at least three individuals are available to
assist with the mounting of the backboard to the unit. A minimum of two, preferably
three, individuals is required for safe assembly of the backboard to the unit.
5.
Position the Quick Change Backboard Bracket (item 13) to the back of the board and
install a 3/8-16 x 1” bolt with lock washer and flat washer in the lower two holes of the
mounting plate and into the two tapped insert holes of the LXP backboard as shown in
figure 2. Tighten these bolts securely.
6.
Using the hardware supplied with the goal, insert the two carriage bolts through the top
goal mounting holes on the backboard and loosely install the nuts and washers on the
back side of the board. Slide the goal over the carriage bolt heads and over the studs on
the front of the board. Install the flat washer, lock washer and nuts on the studs and
tighten securely. Tighten the two top carriage bolts securely.
Figure 2
7.
Attach the backboard brace brackets (item 12) to the top corners of the backboard as
shown in figure 3. Use the 3/8-16 x 1” carriage bolts with whizlock nuts for this
assembly.
Figure 3
Item 13
LXP
Backboard
Goal
LXP
Backboard
Item 12
